In this article we introduced the numerical control machine reducer design and its calibration.
Machine reducer design. Reducer is composed of closed in the casing of gear transmission. Between the prime mover and work machine is commonly used as the reduction gear. High speed by the belt drive of the motor and reducer, drive belt conveyor after reducing speed. Because of the speed reducer compact structure, high efficiency, convenient operation and maintenance, and wide application.
Calibration of nc machine. Tighten the bolt, if necessary, use filler piece placed under the bolt to adjust levels. With bearing beam of the forklift or jack only from two side or the back of the bearing beam itself mention leveling machine, don't rely on any other parts of the machine.
1. The machine must use precision level along the two axial leveling:
2. Two racks: check whether they completely in phase, in order to completely in phase, when it is necessary to use filler piece (this is necessary for the proper use of the machine).
3. The roller on the vertical axis: put on the center of the roller, the level on the direction of motor/card yoke.
4. On the side roller transverse: put two level two close to each frame of a roller.
The above is the reducer design and calibration of numerical control machine.